Author Topic: Problems upgrading to .50  (Read 1663 times)

0 Members and 1 Guest are viewing this topic.

Carlos del Valle

  • Newbie
  • *
  • Posts: 3
    • View Profile
Problems upgrading to .50
« on: June 22, 2012, 17:56 »
Hello Tommy

I've just downloaded the new 1.50 soft and when I install it, the old user interface pops up. When I uninstall all previous instalations with the control panel uninstaller, and reinstall the new version, again the old user interface appears. It says 1.50 on top, but the new features as pink noise pass band and low frec. delay are not anywhere. Also, my old traces are still in the memories.

Any way I can fully uninstall the old version and put the new one?

Thanks very much.


Carlos del Valle

  • Newbie
  • *
  • Posts: 3
    • View Profile
Re: Problems upgrading to .50
« Reply #1 on: June 22, 2012, 17:56 »
Sorry, it's Windows 7 Pro edition 32b

TomyN

  • Administrator
  • Sr. Member
  • *****
  • Posts: 286
  • Master of SATlive
    • View Profile
    • SATlive Homepage
Re: Problems upgrading to .50
« Reply #2 on: June 27, 2012, 11:36 »
Hi Carlos,

well, you're using 1.50 :-)

It should load your 'old' quick-taces, and the uninstaller only removes the program files but no stored traces.

To activate all signals, simply open the pop-up menu of the signal-generator (click with the right mouse button in the area of the signal generator). In the pop-up menu check the 'show all signals' option.

Tomy
Dipl.-Ing.(FH) Thomas Neumann
SIM-II Operator
DANTE Level1 certified